The submersible wastewater pump is a common sewage pump with a wide range of use. The main reason for the leakage of the submersible wastewater pump is the wear or aging of the sealing device. When this happens, you can replace the new seal or take the following measures Several ways to solve this.

submersible wastewater pump

1. If the rubber sealing ring in the nylon sealing seat is worn, the sealing ring can be taken out and installed in another position. If the tightening spring on the sealing ring loses its elasticity or breaks, the spring can be removed and tied with a steel wire or iron wire of an appropriate diameter. tight.

2. If the rubber sealing ring of the oil hole is damaged, you can find a piece of tape, cut it into a hole slightly larger than the bolt, add a flat washer to it, and put it in the oil inlet hole of the bolt together.

3. The sealing ring of the submersible wastewater pump loses its elasticity due to long-term use. At this time, the sealing ring can be taken out, and then find a piece of paper or cloth with a thickness of 0.3 to 0.5 mm and cut it into a pad slightly larger than the original sealing ring and fit it into the groove, and install the original sealing ring at the end.